Version: [5181] Bambi - QGIS Integration 7.0.1 Experimental

Version 7.0.1
    Added:
    - AGL Profile tool: the x axis can also show the frame index, next
to distance flown and time since start. A new Animal markers selector
(None, Detections, Tracks) puts a tick along the bottom of the plot at
every frame that shows animals, taller where there are more of them,
and the hover readout gives the count for the frame under the cursor.
Tracks count distinct animals per frame, interpolated frames included.
Folders from before the GeoPackage store are read from their
detections.txt / tracks_pixel.csv without a migration.
    Fixed:
    - Camera Calibration tool: the wizard broke as soon as an image
was shown. A misspelt attribute in the magnifier made every repaint of
the annotation view raise an error; this has been in every release
since 4.0.0.
    - Camera Calibration tool: with the magnifier on, a click placed
the point somewhere other than where the loupe pointed. The loupe
mapped the cursor over the whole panel, including the dark bars beside
a letterboxed image, while clicks mapped over the image only, so the
two drifted apart away from the centre. Both now use the same mapping,
the loupe stays centred on the clicked pixel at the image border, and
points already placed show inside the loupe.
    - AGL Profile tool: a DEM mesh set by hand could come up empty
with no explanation. Any failure to read the mesh or cast against it
was swallowed and reported only as "No DEM ground under the route".
The status line now says which case it is: the mesh could not be read
(with the error), no .glb/.gltf was found for the path given, or the
mesh does not cover the poses, which usually means it is a different
DEM from the one the flight was processed with. When every ray misses,
the message gives the pose and mesh extents side by side, so a DEM
from another flight is told apart from a hole in the mesh. A metadata
JSON seeded from the dock no longer overrides a DEM picked by hand, a
.json entered in the DEM field is read as the metadata of the mesh
beside it, and pressing Enter in the DEM field reloads the profile.

yes

cpraschl

2026-11-02T14:05:42.247848+00:00

3.22.0

3.99.0

None

yes

Version management

Plugin details