3.0.0 - 2018/04/08 - Update to Qgis 3 and minor improvements
<p>1.5.2 - 2018/03/11 - Improvements:
- Added offset to Point Style Label
- Added Progress Bar information to the network calculation process
with Cancel option
- Added Progress Bar information to the Flow calculation process with
Cancel option
- Added Option to Change QEsg display styles direct from QEsg toolbar
<p>1.5.1 - 2018/03/11 - Improvement and bugs: (thanks to Thiago
Decina)
- Increased fields size from 2 to 6 digits to allow networks with up
to 999999 Manifolds with 999999 reaches each
- Fixed and Improved Table sort routine on Flow Calculation Class
<p>1.5.0 - 2018/03/03 - Incorrect calculation of the initial water
depth (thanks to Thiago Decina)
<p>1.4.6 - 2016/11/18 - Improvement and minor bugs:
- The exported DXF file had ground Elevation duplicated instead of
pipe manifold elevation
- The ezDXF library is now only loaded when needed
<p>1.4.5 - 2016/09/26 - Improvement and minor bugs:
- The Export DXF tool now create DXF file that can be imported into
Sancad
- Option to Match Pipe Upper Edge is now available
- Replaced dxfwrite with the newer ezdxf python library
- Added maximum speed user parameter
- Minimum covering error on big diameters
<p>1.3.3 - 2016/08/18 - Minor bug:
- When 'Maximum downstream plunge' parameter was set, the logic loop
was using minimum slope smaller than possible, ignoring minimum
covering even causing negative depth
<p>1.3.2 - 2016/08/10 - Improvements and minor bugs:
- Bug not consider Progressive Diameter option on big slopes changes
- Added option to use full decimal length precision instead Sancad's
(0 decimal)
- Increased 'LENGTH' field precision to 3 decimals
<p>1.3.1 - 2016/08/09 - Minor bugs:
- Null Node shapefile creation above Qgis 2.14.5
<p>1.3.0 - 2016/08/08 - Minor bugs:
- When 'Maximum downstream plunge' parameter was set, the logic loop
was not recalculating the slope on each Diameter increase
- Also check Duplicated PVM identification when 'Check Polylines'
button clicked on Rename Dialog
- Use the bigger diameter available even without flow capacity and add
Warning to the 'OBS' Field
- Virtual length issue for reaches with CONTR_LADO=0
<p>1.2.0 - 2016/07/11 - Improvements and minor bug:
- Added Manhole representation to Profile
- Added libraries information to this metadata
- Added prefix to Blocks layer names too on exported DXF
- Bug: Tiny Unnecessary deepening below interference on elevated
slopes
<p>1.1.0 - 2016/07/02 - Improvements:
- Added DXF Export option
<p>1.0.1 - 2016/06/22 - Improvements:
- Added Examples Menu
<p>1.0.0 - 2016/06/21 - Initial Release